A200SMC Setup Information Below you will find a table showing how to connect the stepper motors that we carry to our A200SMC stepper motor controller board. Besides connecting the motors to the terminal blocks of the board, you must install the software (available for download at http://www.steppercontrol.com/software.html) and connect your power supply to the jack on the controller board. The image above shows how the positions on the terminal blocks of the A200SMC are numbered. To connect your motor to the A200SMC simply match up the color of wire shown in the table cells below with the positions shown as the column headings.   Position Motor 1 2 3 4 5 6 NEMA17BSM NEMA17DSM NEMA17ESM NEMA17FSM NEMA23KSM No Wire NEMA23LSM* Top Top Top Bottom Bottom Bottom NEMA23MSM NEMA23NSM NEMA23QSM *NEMA23LSM The "Top" and "Bottom" above the wires for the NEMA23LSM refer to the top and bottom stacks of the motor, as designated in the image to the left.
Home - Controllers - Motors - Software - Order - FAQs - Contact Us Copyright © 2004, Mill-Shaf Technologies, Inc. All Rights Reserved